«
»

Re-inking a Pre-Inked iStamp Rubber Stamp

  • Always re-ink your iStamp rubber stamp with the same color of the original stamp
  • Remove the handle
  • Determine the amount of ink needed for your size / model number
  • Small to mid-sized stamps require 3 to 5 drops of iStamp refill ink per port
  • Large stamps require 5 to 8 drops of iStamp refill ink per port
  • Place the required amount of iStamp ink into the ink ports
  • Reattach the handle
  • Let stamp sit for two hours before use to allow ink to soak into stamp
Share

This entry was posted on Friday, November 20th, 2009 at 5:58 pm and is filed under Pre Inked Stamps. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

One Response to “Re-inking a Pre-Inked iStamp Rubber Stamp”

  1. Aisling says:
    March 23, 2011 at 11:18 am

    How do you remove the handle?

Leave a Reply